Discussions related to PC-3000
Please no pirated software here!
February 14th, 2024, 21:57
Hello guys hows your new year?
i received this drive that doesnt spin at all and stay BSY with error LED:0x000000BD FAddr:0x000059D8
iv tried the official guide
https://blog.acelab.eu.com/how-to-fix-a ... -chip.htmlbut with donor PCB "after Repeat the unlocking steps (1-6) " i cannot enter the command OI1 ..... i will get LED:0x000000BD FAddr:0x000059D8 !AGAIN
and if i skip this command and Repeat the unlocking steps (7-9). the drive spinds but i get Waiting drive spin up ! therefore i cannot use the terminal !
with original PCB is the same.....the drive spins if i change to 82 34 56 78 but i cant enter the command OI1
i also noticed that nomatter how many times i write the patient rom into DONOR PCB it will show the SN of the DONOR.........
any help will be very very helpfull
February 16th, 2024, 3:45
i also noticed that nomatter how many times i write the patient rom into DONOR PCB it will show the SN of the DONOR.........
try ROm Programmer to write Patient ROM or change Terminal Speed,
Good Luck...
February 17th, 2024, 9:10
lifeguarddubai wrote:i also noticed that nomatter how many times i write the patient rom into DONOR PCB it will show the SN of the DONOR.........
try ROm Programmer to write Patient ROM or change Terminal Speed,
Good Luck...
programmer ? Sir this drive has no tsop rom on it! the rom is stored inside the nand flash!
anyway when i disconnect the pcb from the patient drive it gives me the patient SN but when i connect to the patiend hdd it shows the donor drive SN
February 17th, 2024, 11:10
it has NOR flash (serial flash) albeit not TSOP indeed, but BGA. It is the ~3x2mm chip near the DRAM.
ROM is also present in NAND and some parts of it are read from there normally.
pepe
February 17th, 2024, 11:58
pepe wrote:it has NOR flash (serial flash) albeit not TSOP indeed, but BGA. It is the ~3x2mm chip near the DRAM.
ROM is also present in NAND and some parts of it are read from there normally.
pepe
yes right Sir . you 100%...unfortunatelly im stuck.................... maybe non compatible BGA on the donor? but the drive spins when i set 82 34 56 78
however BSY and same terminal error
February 20th, 2024, 1:41
can somebody tell me which is the correct position for the read channell? i tried many times but is still get the error LED:0x000000BD FAddr:0x00008004
should i short before or after the tech Unlock Handshake"?
should i keep the position untill the drive get ready ? if the position is correct will the drive keep spinning or will stop spins?
- Attachments
-
-
-
-
Powered by phpBB © phpBB Group.